Ethernet Parameters
The Ethernet parameters are described in the table below.
Ethernet Parameters
|
Parameter |
Description |
||||||
|---|---|---|---|---|---|---|---|
|
configure voip > media settings > arp-manager-timeout [ArpManagerTimeout] |
Defines the maximum duration or timeout (in seconds) that the device waits for an Address Resolution Protocol (ARP) reply. If no reply is received within this duration, the device terminates the call. The valid value is 1 to 20. The default is 3. Note: The device first checks its internal ARP table for a MAC address that matches the destination IP address. It only sends an ARP request if no match is found. |
||||||
|
[MIIRedundancyEnable] |
Enables the Ethernet Interface Redundancy feature. When enabled, the device performs a switchover to the second (redundant) Ethernet port upon detection of a link failure in the primary Ethernet port. When disabled, the device operates with a single port (i.e. no redundancy support).
For more information on Ethernet interface redundancy, see Ethernet Interface Redundancy. Note: For the parameter to take effect, a device restart is required. |